MCQ Questions Electrical Engineering Generation of Electrical Power
As well as questions about your reasons for applying to the role and the employer in question, engineering recruiters will be assessing your potential in the areas that is crucial to any engineering role: technical expertise. Engineers may be asked to perform feats of fantastic technical prowess, but it will be as as part of a Justice League rather than as a solo engineering superhero.
The interviewer is almost as nervous as the candidate in most interviews. You might wonder if you look confident enough, if you will hire the right person, or if you are asking the right engineering interview questions. The last question is arguably the most crucial part to worry about when you’re interviewing candidates.
The best engineering interview questions to ask candidates should be questions that reveal they have the skills required for the job. If you need a problem solver, ask questions about past experiences. If they need to have a specific skill set, ask them directly about their skills. This chapter consisting Electrical engineering MCQ Questions Electrical Engineering Generation of Electrical Power
There are six major branches of engineering which include Electrical, Mechanical, Civil, Management, Geotechnical, and Chemical with many different subcategories under each main branch of engineering such as Structural or Biomedical engineering.
This article will get into the top engineering interview questions to ask candidates, eight types of interview questions, how to choose the questions you ask, and then will list excellent questions you can choose from. Let’s jump right in.
You can practice interviews using the resources available from our partners. MCQ Questions Electrical Engineering Generation of Electrical Power are given below.
MCQ Questions Electrical Engineering Generation of Electrical Power - Set - 4
Question 1:
For the induced draught the fan is located
(a) near bottom of chimney
(b) near bottom of furnace
(c) at the top of the chimney
(D) anywhere permissible
Correct Answer – (B)
Question 2 :
Artificial draught is produced by
(a) air fans
(b) steam jet
(c) fan or steam jet
(d) all of the above
Correct Answer – (D)
Question 3 :
The draught in locomotive boilers is produced by
(a) forced fan
(b) chimney
(c) steam jet
(d) only motion of locomotive
Correct Answer – (C)
Question 4 :
For forced draught system, the function of chimney is mainly
(a) to produce draught to accelerate the combustion of fuel
(b) to discharge gases high up in the atmosphere to avoid hazard
(c) to reduce the temperature of the hot gases discharged
(d) none of the above
Correct Answer – (B)
Question 5 :
The draught produced, for a given height of the chimney and given mean temperature of chimney gases
(a) decreases with increase in outside air temperature
(b) increases with increase in outside air temperature
(c) remains the same irrespective of outside air temperature
(d) may increase or decrease with increase in outside air temperature
Correct Answer – (A)
MCQ Questions Electrical Engineering Generation of Electrical Power
Question 6:
The artificial draught normally is designed to produce
(a) less smoke
(b) more draught
(c) less chimney gas temperature
(d) all of the above
Correct Answer – (D)
Question 7:
For the same draught produced the power of induced draught fan as compared to forced draught fan is
(a) less
(b) more
(c) same
(d) not predictable
Correct Answer – (B)
Question 8:
Artificial draught is produced by
(a) induced fan
(b) forced fan
(c) induced and forced fan
(d) all of the above
Correct Answer – (D)
Question 9:
The draught produced by chimney of given height at given outside temperature
(a) decreases if the chimney gas temperature increases
(b) increases if the chimney gas temperature increases
(c) remains same irrespective of chimney gas temperature
(d) may increase or decrease
Correct Answer – (B)
Question 10:
In a boiler installation the natural draught is produced
(a) due to the fact that furnace gases being light go through the chimney giving place to cold air from outside to rush in
(b) due to the fact that pressure at the grate due to cold column is higher than the pressure at the chimney base due to hot column
(c) due to the fact that at the chimney top the pressure is more than its environmental pressure
(d) all of the above
Correct Answer – (B)
- NCERT Solutions Class 11 Physics Chapter 1 : Physical world
- NCERT Solutions Class 11 Physics Chapter 2 : Units And Measurements
- NCERT Solutions Class 11 Physics Chapter 3 : Motion In A Straight Line
- NCERT Solutions Class 11 Physics Chapter 4 : Motion In A Plane
- NCERT Solutions Class 11 Physics Chapter 5 : Laws of Motion
- NCERT Solutions Class 11 Physics Chapter 6 : Work Energy Power
- NCERT Solutions Class 11 Physics Chapter 7 : Rotational-Motion
- NCERT Solutions Class 11 Physics Chapter 8 : Gravitation
- NCERT Solutions Class 11 Physics Chapter 9 : Mechanical Properties of Solids
- NCERT Solutions Class 11 Physics Chapter 10 : Mechanical Properties of Fluids
- NCERT Solutions Class 11 Physics Chapter 11 : Thermal Properties of Matter
- NCERT Solutions Class 11 Physics Chapter 12 : Thermodynamics
- NCERT Solutions Class 11 Physics Chapter 13 : Kinetic Theory
- NCERT Solutions Class 11 Physics Chapter 14 : Oscillations
- NCERT Solutions Class 11 Physics Chapter 15 : Waves
Multiple Choice Questions for Competitive Exams
- MCQ Questions Class 11 Chemistry Environmental Chemistry with Answers
Set -1 Set -2 Set -3 Set -4 Set -5 - MCQ Questions Class 11 Chemistry Hydrocarbons with Answers
Set -1 Set -2 Set -3 Set -4 Set -5 - MCQ Questions Class 11 Chemistry Organic Chemistry with Answers
Set -1 Set -2 Set -3 Set -4 Set -5 - MCQ Questions Class 11 Chemistry The p Block Elements with Answers
Set -1 Set -2 Set -3 Set -4 Set -5 - MCQ Questions Class 11 Chemistry The s Block Elements with Answers
Set -1 Set -2 Set -3 Set -4 Set -5 - MCQ Questions Class 11 Chemistry Hydrogen with Answers
Set -1 Set -2 Set -3 Set -4 Set -5