MCQ Questions Electrical Engineering Silicon Controlled Rectifiers

Silicon Controlled Rectifiers-5

MCQ Questions Electrical Engineering Silicon Controlled Rectifiers

Take a look at these MCQ Questions Electrical Engineering Silicon Controlled Rectifiers for engineering interview questions and our tips on how to answer them. If you’re applying for an engineering internship, graduate scheme or entry-level job, you’ll face at least one interview as part of an engineering employer’s recruitment process. You may be interviewed by one or more members of the HR team, senior members of the engineering team you’d be joining or a mixture of both. In this section we will study MCQ Questions Electrical Engineering Silicon Controlled Rectifiers. 
As well as questions about your reasons for applying to the role and the employer in question, engineering recruiters will be assessing your potential in the areas that is crucial to any engineering role: technical expertise. Engineers may be asked to perform feats of fantastic technical prowess, but it will be as as part of a Justice League rather than as a solo engineering superhero.

The interviewer is almost as nervous as the candidate in most interviews. You might wonder if you look confident enough, if you will hire the right person, or if you are asking the right engineering interview questions. The last question is arguably the most crucial part to worry about when you’re interviewing candidates.

MCQ Questions Electrical Engineering Silicon Controlled Rectifiers - Set - 5

Question 1: 

When SCR starts conducting, then ……………. loses all control

  1. Gate
  2. Cathode
  3. Anode
  4. None of the above

Correct Answer – (A)

Question 2 : 

An SCR can exercise control over ………. of a.c. supply

  1. Positive half-cycles only
  2. Negative half-cycles only
  3. Both positive and negative half-cycles
  4. Positive or negative half-cycles

Correct Answer – (D)

Question 3 : 

If gate current is increased, then anode-cathode voltage at which SCR closes …………….

  1. Is decreased
  2. Is increased
  3. Remains the same
  4. None of the above

Correct Answer – (A)

Question 4 : 

In an SCR circuit, the angle of conduction can be changed by ……….

  1. Changing anode voltage
  2. Changing gate voltage
  3. Reverse biasing the gate
  4. None of the above

Correct Answer – (B)

Question 5 : 

An SCR is made of silicon and not germanium because silicon ………

  1. Is inexpensive
  2. Is mechanically strong
  3. Has small leakage current
  4. Is tetravalent

Correct Answer – (C)

MCQ Questions Electrical Engineering Silicon Controlled Rectifiers

Question 6: 

We can control a.c. power in a load by connecting …………

  1. Two SCRs in series
  2. Two SCRs in parallel
  3. Two SCRs in parallel opposition
  4. None of the above

Correct Answer – (C)

Question 7: 

When SCR is OFF, the current in the circuit is …………….

  1. Exactly zero
  2. Small leakage current
  3. Large leakage current
  4. None of the above

Correct Answer – (B)

Question 8: 

If firing angle in an SCR circuit is increased, the output …………

  1. Remains the same
  2. Is increased
  3. Is decreased
  4. None of the above

Correct Answer – (C)

Question 9: 

An SCR is turned off when …………..

  1. Anode current is reduced to zero
  2. Gate voltage is reduced to zero
  3. Gate is reverse biased
  4. None of the above

Correct Answer – (A)

Question 10: 

When an SCR is turned on, the voltage across it is about ……….

  1. Zero
  2. 10 V
  3. 1 V
  4. 1 V

Correct Answer – (D)

MCQ Questions Electrical Engineering Silicon Controlled Rectifiers
MCQ Questions Electrical Engineering Power Electronics

Multiple Choice Questions for Competitive Exams